2JR Fiesta ST Ultra-Quiet 3" Side Exit
Special Price
$569.78
Regular Price
$679.00
In stock
SKU
FTSE
2JR does it once again with their custom built side exit for the Fiesta ST. We've built this exhaust for the best performance, sound and weight savings possible over any exhaust on the market. Made from 4mm thick 304 Stainless Steel for long life, corrosion resistance and strength in the harshest track environment. Next we've added steel encased rubber hangers that bolt to the chassis at stock location points for a perfectly tight fit centered on the sill opening - this allows for no burning of the sill. Then we use an oval stainless tail section for ground clearance over the pinch weld. For the keeping this completely street legal for sound, 2JR uses a large free flowing stainless resonator to designed to keep the exhaust tone completely tame (even with a catless downpipe) while keeping backpressure at an absolute minimum. Lastly - and most importantly, is the weight savings. Lighter than any other widely used system on the market with approx. 35% less piping and weight.
Will bolt to the stock downpipe or the 2JR downpipe (or any other aftermarket production downpipe).
NOTE: you will need to trim the pinch weld in a 4" section using a die grinder or similar. Then you will need to trim the plastic surround inside the sill where the factory cutout is located. This can be done with a dremel. Both are quite easy to do.
SOUND CLIP: https://www.facebook.com/2JRacing-206550699368164/
SEE BOTTOM OF PAGE FOR INSTALL INSTRUCTIONS
Will bolt to the stock downpipe or the 2JR downpipe (or any other aftermarket production downpipe).
NOTE: you will need to trim the pinch weld in a 4" section using a die grinder or similar. Then you will need to trim the plastic surround inside the sill where the factory cutout is located. This can be done with a dremel. Both are quite easy to do.
SOUND CLIP: https://www.facebook.com/2JRacing-206550699368164/
SEE BOTTOM OF PAGE FOR INSTALL INSTRUCTIONS